Peltier Fermenter Cooling Kit

 

Peltier Fermenter Cooling Kit.

Cool your fermenter without a refrigerator with solid state peltier chips. We’ve machined aluminum blocks so you can easily make your own DIY peltier cooled fermenter and provide matching fans. A peltier chip is a solid state chip that runs on 12VDC and gets cold on one side and hot on the other. By mounting a peltier chip onto our aluminum block and using the fan to pull heat off of the hot side of the chip, you can provide excellent temperature control. Each aluminum block can support two peltier chips. One block with two chips will support typical ale fermentations and pull a 7 gal. fermenter down by about 10 to 20 degrees (depending on the quality of your chip, insulation, etc.). For lagers and cold aging, two blocks with 4 chips will perform twice as well.

Peltier Kit for For Stout Tanks and Kettles Fermenters only (7.3, 10, 12.5 gal size with approx. 11.8″ diameter). Will not work with any other fermenter.

Includes:

  • (1) Aluminum block for mounting (2) peltier chips. 4″W x 9.5″L with 8 drilled and tapped holes for two fans, plus 8 small holes with pins to trap the 40x40mm chip (chip not included). Includes chamfers for tie wraps on top and bottom. Milled to match shape of fermenter.
  • (2) CPU Fans, 12VDC type.
  • Does not include power supply, temperature controller, insulation, peltier chips.
  • Comes un-assembled (machined aluminum block, 2 fans, and 8 pins are all separate

FAQ about Setup

This entry was posted in beer, Food and drink. Bookmark the permalink.

Leave a Reply